Agsar Epoxy Paint is supplied as a two pack system where Epoxy Base and Hardener are packed separately. Epoxy base and hardener have to be mixed just before use and mixed paint must be completely used within an hour. It gives a very smooth finish, which can withstand extreme climatic conditions. It is ideally suitable for use on pipelines in industries, which are constantly exposed to the action of sun, rain and fumes. It can withstand wear and tear better than any other paint. It is an excellent choice for coating the exterior of chemical plants and machineries such as conveyor belts etc and Marine Equipments.
| 1. | Viscosity of supply | Epoxy Base & Hardener :10 to 15 sec by FC No.B6 at 30° C |
| 2. | Shades available | White, Golden Yellow, Lemon Yellow and Smoke Grey |
| 3. | Packs available | 20,4 and 1 Lit |
| 4. | Finish | Smooth & Glossy |
| 5 | Surface to be painted | Ferrous metals |
| 6 | Primer to be used | Agsar Epoxy Red Oxide Metal Primer or Agsar Epoxy Zinc Chrome Yellow Primer |
| 7. | Method of application | Brushing or spraying |
| 8. | Thinner to be used | Agsar Special purpose Epoxy Thinner |
| 9 | Drying time | Surface drying within 3 hours, hard drying within 8 hours. The above varies with atmospheric temperature and humidity. |
| 10. | Coverage capacity | 75-80 sq.feet /litre per coat depending upon the surface. |
| 11. | General Directions for use | The Agsar Epoxy base and hardener are mixed in the ratio of 4:1 by volume in just sufficient quantity, so that the mixed Epoxy paint is used up completely within about 30 to 40 minutes of mixing. The surface to be painted should be dry and free from grease, oil, dirt, rust and other loose particles. A second coat should be applied after drying for 10 to 12 hours. |