Agsar No.1 Wall Putty is based on white cement, designed specially for both interior and exterior to give smooth finish. It can be applied on all type of interior and exterior cement plaster, ceilings, asbestos sheet, concrete etc. It is easy to apply and gives excellent longevity to walls.
| 1. | Packs available | 20 kg, 40kg |
| 2 | Surface to be painted | Interior walls, wooden surface, asbestos sheet, bricks and concrete surfaces. |
| 3. | Primers to be used | Agsar Cement Printer water base / oil base |
| 4 | Method of Application | Putty Knife |
| 5. | Thinner to be used | 400 to 500 ml of water for 1 kg of wall putty |
| 6. | Drying Time | 4 hours |
| 7. | Average covering capacity | 15 to 18 sq.feet/kg per application. This varies with the surface conditions. |
| 8. | Finish | Silky smooth finish |
| 9. | General directions for use | The surface to be applied must be free from any loose material, dust oil or grease etc., Surface imperfections such as holes and dents are to be filled using a mixture of white cement and fine sand in the ratio of 1:3. However, minor cracks can be filled with this wall putty. Mix Agsar No.1 Wall Putty with 40-50% water. Water is to be added gradually to the wall putty for getting desired consistency. It is very important that water should be added to the putty to make a paste and not vice versa. After complete mixing, apply the paste on the prepared surface using putty blade from bottom to upward direction. Apply the second coat after 4 to 6 hour drying of first coat. Maximum coating thickness should not exceed more than 1.5 mm. Allow the surface to dry overnight and level the surface with fine emery paper (500 no.) for smooth finish. |